Stainless steel
Hot Rolled Stainless Sheet
No.1 hot rolled sheet in 304 / 316L — 3–12 mm, cut to length up to 6000 mm.
3–12 mmThickness
≤ 2000 mmWidth
Available specification
| Grades | Thickness | Width / diameter | Standard |
|---|---|---|---|
| 304 · 316L | 3–12 mm | ≤ 2000 mm | ASTM A240 / EN 10088-2 |
Ranges shown are standard availability; non-standard sizes can be made to order. Thickness is nominal — tolerance judged to ASTM A480 / EN 10088-2.
Typical applications
- Structural fabrication
- Tank and silo shells
- Platforms and walkways
Delivery and inspection
- Annealed and pickled, ready for welding
- Cut-to-length with squareness checked
- Mill or trimmed edge, your choice
Need a quote or technical support?
Send the grade, size, quantity and destination port — we reply with FOB / CIF within 24 hours.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Tanks and vessels — atmospheric tank shells, bottom plates
- Structures — platforms, stairways, supports
- Environmental equipment — scrubber internals, dust collector housings
- Marine and port — hatch covers, mooring fittings
- Wear parts — chute liners (in heavier gauges)
Selection FAQ
- Is the hot rolled plate pickled?
- Standard supply is No.1 (hot rolled, annealed and pickled). Unpickled black coil must be specified separately.
- Can thick plate be decoiled and levelled?
- Yes, cut to length. Heavy gauges carry more internal stress after levelling — tell us the downstream process.
Not sure which grade fits? Use the grade selector