"Stainless steel doesn't rust" is shorthand. The precise statement is: it resists corrosion because there is a chromium-rich passive film on the surface. This film is only a few nanometers thick and can self-repair after being damaged — provided the surface is clean and oxygen is present. After welding, hot working, or iron contamination, the film is damaged but cannot repair itself, and corrosion starts right there.
One-Sentence Judgment
If welded, hot-worked, exposed to carbon steel tools, or used in food/pharmaceutical/high-purity water/coastal environments, pickling and passivation are mandatory; un-welded cold-rolled 2B/BA sheet used in dry indoor environments can skip it.
When the Passive Film Is Damaged
- Welding: Oxidation colors (blue, purple, black) appear in the weld and heat-affected zone — that is oxide scale, not passive film;
- Hot working/heat treatment: High-temperature oxidation forms oxide scale, which must be removed after cooling;
- Iron contamination: Carbon steel fixtures, ordinary steel wire brushes, and cutting tables shared with carbon steel can embed iron particles into the surface, which rust first when exposed to moisture;
- Machining residue: Cutting fluid, oil, grinding debris.
Pickling and Passivation Are Two Different Things
- Pickling: Using acid to dissolve oxide scale and the chromium-depleted surface layer, exposing a clean metal surface;
- Passivation: Using an oxidizing medium (commonly nitric acid or citric acid) to allow the surface to reform a chromium-rich oxide film.
Pickling without passivation is like washing your face without applying skincare — the surface is clean, but the film hasn't grown back, and it will still rust when exposed to a humid environment. Many cases of "still rusting after pickling" are due to skipping the passivation step.
Relevant standards include ASTM A380 (cleaning and descaling) and ASTM A967 (chemical passivation) — the specific method and acceptance criteria are determined by project requirements.
Four Scenarios Where It's Required
- Welded structures: Welds and heat-affected zones must be treated, either by local application of pickling paste or full immersion in a pickling bath;
- Food/pharmaceutical/high-purity water: Not only must oxide scale be removed, but also no residue and no dead corners (often combined with electropolishing);
- Coastal/chemical environments: Even if the appearance is clean, iron contamination will manifest within six months;
- Subsequent coating/lining: The surface must be clean, oil-free, and rust-free, otherwise adhesion cannot be guaranteed.
Scenarios Where It Can Be Skipped
- Un-welded, un-hot-worked cold-rolled sheet (2B/BA) used for decorative and structural parts in dry indoor environments;
- Finished parts that have already been passivated at the factory and have not come into contact with carbon steel during transport and processing.
Common Pitfalls
- Using hydrochloric acid for pickling: Hydrochloric acid contains chlorine, which causes pitting, especially on 304; nitric acid or dedicated pickling paste should be used;
- Insufficient rinsing after pickling: Residual acid remains in crevices, actually accelerating corrosion;
- Brushing welds with a carbon steel brush: Contaminating while treating;
- Treating only visible welds, missing the back side and root;
- Delivering without testing after passivation (blue dot test, copper sulfate test).
Tell us the structural form (whether welded), the service environment, and the applicable standard, and we will advise whether pickling and passivation are needed and which method to use; for workpieces that require treatment, we can also provide treatment records according to your acceptance method.
